Extension Amc2-8Ioe - Bosch APC-AMC2-4R4CF Installation Manual

Access Modular Controller 2
The AMC2 has eight analog input devices and eight relay outputs. With its analog input
devices, the AMC2 verifies, for example, if a lock is closed or open. The relay outputs can be
used to activate lock mechanisms if access is granted, or activate an external alarm system if
an intrusion or system alert is detected.
The AMC2-16IOE electronics are completely covered by a plastic housing.
Notice!
The AMC2-16IOE has no display. The information about the input and outputs will be shown
on special pages of the AMC2 display.
Notice!
An AMC2-16IOE provides signals only to the AMC2 to which it is connected. Signal transfer to
another AMC2 is not possible.
Notice!
Depending on the software system up to 3 extension modules can be connected at random.
3.1.2

Extension AMC2-8IOE

To optimize the utilization of the available signals the extension module can be delivered in a
reduced version, too. The AMC2-8IOE has eight inputs and eight outputs. The places of the
pluggable screw connectors are on one side of the module - the other side will be closed by
the housing.
Figure 3.12: Extension module AMC2 8IOE
Notice!
The AMC2-8IOE is identical in all respects to the AMC2-16IOE except in the number of inputs
and outputs. Information in this manual refers to all three extensions described here, unless
explicitly stated otherwise.
Bosch Access Systems V.B. Installation manual
Introduction | en 15
2020-01 | V02 |