Access Modular Controller 2
Figure 3.27: Jumpers at the bottom side
Figure 3.28: Jumpers at the bottom side
Figure 3.29: Jumpers at the bottom side
Bosch Access Systems V.B.
19
Jumper for setting either voltage free relay output ("dry" mode) or looped-in voltage
from the AMC2 internal power supply ("wet" mode).
20
Jumper: Potential equalization between different systems and earth ground (shield)
for the bus systems.
21
Jumper: Equalization of potential between different systems and earth ground
(shield) for the extension interface.
19
Jumper for setting either voltage free relay output ("dry" mode) or looped-in voltage
from the AMC2 internal power supply ("wet" mode).
Installation manual
Introduction | en
23
2020-01 | V02 |