24
en | Introduction
2020-01 | V02 |
20
Jumper: Equalization of potential between different systems and earth ground
(shield) for the extension interface.
18
Jumper for setting either voltage free relay output ("dry" mode) or looped-in voltage
from the AMC2 internal power supply ("wet" mode).
19
DIL switch for setting the board address.
20
Jumper: Equalization of potential between different systems and earth ground
(shield) for the extension interface.
7
Jumper for setting either voltage free relay output ("dry" mode) or looped-in voltage
from the AMC2 internal power supply ("wet" mode).
8
Jumper: Equalization of potential between different systems and earth ground
(shield) for the extension interface.
Installation manual
Access Modular Controller 2
Bosch Access Systems V.B.