Epson Stylus Photo PX700FW Service Manual page 252

Epson Artisan 800/Epson Stylus Photo PX800FW/TX800FW/Epson Artisan 700/Epson Stylus Photo PX700W/TX700W
• The EJ Frame Assy must be lowered most.
Figure 5-35. Position of EJ Frame Assy
• Check that the PG cams; located on both the left side and the right side of t h e
Carriage Shaft and the CR guide plate, are in the PG-position.
Left side
Right side
Figure 5-36. PG position when adjusting
ADJUSTMENT
Adjustment procedure
1. Move the carriage to the home position.
0 column side
2. Loosen all the screws the secure each parallelism adjustment bushing.
3. Attach the parallelism adjustment jigs to the printer mechanism.
Place the rear of Jig on
( Fig. 5-36 )
Carriage Shaft.
Location of the bits of dial gauge (A) (B)
Adjustment without Using Adjustment Program
https://www.manualsbooks.com
Location of the bits of dial gauge (C) (D)
Place Jig aligning the bits with the ribs shown above.
Place Jig aligning the bits with the ribs shown above.
Figure 5-37. Installing the parallelism adjustment jigs
Revision C
( Fig. 5-34 )
Place the front of Jig on CR
Guide Plate.
237
Confidential