Numbering Extensions And C.o. Lines - Samsung OfficeServ 7200 Installation Manual

Hide thumbs Also See for OfficeServ 7200:
Table of Contents

Advertisement

CHAPTER 8. Ошибка! Используйте вкладку "Главная" для применения 제목 1 к тексту, который должен здесь
отображаться.

8.3 Numbering Extensions and C.O. Lines

Once the OfficeServ 7200 is booted, the MP20/MP20S /LCP verifies the boards mounted
on each slot and saves this information as the default configuration of the system.
According to the setting of the S3 switch (SW6, SW7, SW8) of the MP20/MP20S /LCP,
the OfficeServ 7200 assigns 3 or 4 digits to C.O. lines, extensions, and extension groups.
Refer to 'Chapter 4. Mounting and Replacing Boards' of this manual for details on setting
the S3 switch.
C.O. line numbers from 701 or 7001 are sequentially assigned to the C.O. line board
mounted on Slot 1 of the basic cabinet, and following numbers are continuously assigned
to the next C.O. line board of the next slot. However, only the numbers from 701 to 799 are
assigned when using 3 digits. For example, if an 8TRK is mounted on Slot 1 and an 8TRK
is mounted on slot2, 701 is assigned to the C1/S1/P1 port and 712 is assigned to the
C1/S2/P4 port. (Twelfth C.O. line is assigned to the fourth port of the second slot of the
first cabinet.)
Extension numbers from 201 or 2001 are sequentially assigned to the extension board
mounted on slot 1 of the basic cabinet, and following numbers are continuously assigned to
the next extension board of the next slot. This numbering process continues until the
extension numbers are assigned to all extensions. However, only the numbers from 201 to
349 are assigned when using 3 digits.
The last port of the first 8DLI is assigned to the attendant group as default. All C.O. lines
ring this attendant extension unless the default value is changed. Thus, a phone with an
LCD panel should be connected to the last port of the first 8DLI.
500-549 or 5001-5049 is assigned to an extension group.
The numbers of C.O. lines, extensions, or extension groups can be changed using the MMC
724 program.
8-4
© SAMSUNG Electronics Co., Ltd.

Advertisement

Table of Contents
loading

Table of Contents