Renumbering A Program - Siemens SINUMERIK 840D sl Operating Manual

Machining the workpiece
4.10 Editing a program
See also
Opening additional programs (Page 120)
4.10.4

Renumbering a program

You can modify the block numbering of programs opened in the editor at a later point in time.
Requirement
The program is opened in the editor.
Procedure
Note
If you only want to renumber a section, select the program blocks whose block numbering
you want to edit.
118
1. Press the ">>" softkey.
A new vertical softkey bar appears.
2. Press the "Renumber" softkey.
The "Renumbering" window appears.
3. Enter the values for the first block number and the increment to be used
for numbering.
4. Press the "OK" softkey.
The program is renumbered.
Operating Manual, 03/2013, 6FC5398-6AP40-3BA1
Universal