Editing user data and events
13.4
Setting-up events
In the "Send SMS for the following events" area, select the events using the check box,
which when they occur, an SMS is sent to the user.
● Programmed messages from the part program (MSG)
In the part program, program an MSG command via which you receive an SMS.
Example: MSG ("SMS: An SMS from a part program")
● Select the following events using the <SELECT> key
– The workpiece counter reaches the following value
– The following program progress is reached (percent)
– Actual NC program reaches runtime (minutes)
– Tool usage time reaches the following value (minutes)
● Messages/alarms from the Tool Manager
An SMS is sent if messages or alarms are output to the Tool Manager.
● Measuring cycle messages for tools
An SMS is sent if measuring cycle messages are output that involve tools.
● Measuring cycle messages for workpieces
An SMS is sent if measuring cycle messages are output that involve workpieces.
Universal
Operating Manual, 03/2013, 6FC5398-6AP40-3BA1
6.
Press the "Send test message" softkey.
An SMS message with predefined text is sent to the specified telephone
number.
1.
Select the user whose data you want to edit and press the "Edit"
softkey.
The input fields can be edited.
2.
Enter new data and activate the desired settings.
- OR -
Press the "Default" softkey to accept the default values.
An SMS is sent if the workpiece counter reaches the set value.
An SMS is sent if, when executing a part program, the set progress is reached.
An SMS is sent after the set runtime has been reached when executing an NC
program.
An SMS is sent if the usage time of the tool reaches the set time when executing a
part program (derived from $AC_CUTTING_TIME).
Easy Message (828D only)
13.4 Setting-up events
305