Configure Ospf Routing - Fujitsu 1FINITY L100 User Manual

Initial System Turn Up
Configure IP Connection to DCN

Configure OSPF Routing

Step 8
Configure OSPF routing.
Command:
% set routing routing-instance <routing_instance_name> enabled routing-protocols
routing-protocol ospfv2 <protocol-instance-name> ospf instance
<routing_instance_name> ipv4 router-id <router-id> network <address> <mask> area
<area-id>
Parameter
routing_instance_name
protocol_instance_name
router-id
address
mask
area-id
Command Example:
% set routing routing-instance MCN enabled routing-protocols
routing-protocol ospfv2 OSC ospf instance MCN ipv4 router-id 1.1.1.32
network 172.1.1.0 255.255.255.0 area 0.0.0.0
Step 9
Check the candidate configuration, if desired.
Command:
% show routing routing-instance
Step 10
Save the changes.
Command:
% commit
Step 11
Exit configuration mode.
Command:
% exit
✓
This task is complete.
·
Release 19.1.1 Issue 1.1, May 2021
Value
<MCN>
<OSC>
<1xx.xxx.xxx.xxx>
<1xx.xxx.xxx.xxx>
<1xx.xxx.xxx.xxx>
<x.x.x.x>
Description
Name of routing instance
Name of routing protocol instance
OSPF router id per RFC 2328
IPv4 address, mask, and area ID defining the network on
which OSPF routing is enabled
Fujitsu and Fujitsu Customer Use Only
182