Configure Next-Hop - Fujitsu 1FINITY L100 User Manual

Initial System Turn Up
Configure IP Connection to DCN
Virtuora NC
Virtuora User
NETCONF/
Interface
YANG
WebGUI
DCN
CLI
Remote Users
Figure 90
Daisy Chain LAN Connection
Note: The NE that is being turned up connects to the end of the daisy chain. The other NEs must be configured
to bridge traffic between LCN1 and LCN2 (set
Step 1
Change to CLI configuration mode.
Command:
> configure

Configure Next-Hop

If the NE connects directly to the DCN, the next hop should be the address of the default router.
Step 2
Configure the next hop. This step creates the routing instance if it does not already exist.
Command:
% set routing routing-instance <routing_instance_name> routing-protocols routing-
protocol static <protocol_instance_name> static-routes ipv4 route 0.0.0.0/0 next-
hop next-hop-address <ip_address>
Parameter
routing_instance_name
protocol_instance_name
ip_address
Command Example:
% set routing routing-instance MCN routing-protocols
routing-protocol static FNC static-routes ipv4 route 0.0.0.0/0
next-hop next-hop-address 192.168.229.254
·
Release 19.1.1 Issue 1.1, May 2021
DHCP Server
LAN
Switch
Router
Next-hop IP address
NE Installation Site
neMgmtMode to Bridge or MixMode).
Value
<MCN>
<FNC>
<1xx.xxx.xxx.xxx>
LCN1
1FINITY NE
LCN2
LCN1
1FINITY NE
LCN2
LCN1
1FINITY NE
LAN cable
Description
Name of routing instance
Name of protocol instance
IP address of next hop
Fujitsu and Fujitsu Customer Use Only
174
NE Management
Mode = Bridge