Table of Contents
Advertisement
18
en | Installing a Roof Mount and Camera
7
Installing a Roof Mount and Camera
7.1
Installing the Roof Mount
1.
Notice!
Allow enough room below the Parapet Mount Bracket to route the video, control, and alarm
wires up through the Parapet arm. In certain installations, you may need to lift the Parapet
arm for the camera to clear the top of the wall when it is swung into position. Provide enough
slack in the wires to rotate the pipe arm over the roof and back when camera maintenance is
required.
2.
Figure 7.1: Parapet Wall Mount Bracket and Roof Mount Plate
1
2
3
Notice!
Fasteners are not supplied with the Roof Parapet Mount Kit because the appropriate
fasteners depend on the material to which the mount is attached. The material must
accommodate a minimum pull-out strength of 275 kg (600 lb) (for example, 19 mm (3/4 in.)
minimum for plywood). Fasteners can include bolts, studs, or lag bolts. All fasteners must be
made of corrosion-resistant stainless steel with a diameter of 10 mm (3/8 in.).
All bolts must fully extend through the mounting surface and be secured with a flat washer, a
lock washer, and a nut. All studs must be anchored to concrete or welded to a steel backing
plate. Anchor bolts can be used for blind structures where there is no access to the rear.
3.
2018.06 | 1.0 |
Determine the wall location on the roof for the camera and use the Parapet wall mount
bracket as a template to mark the hole locations.
Prepare the mounting surface for the type of fastener by drilling holes for the mounting
anchors as required.
Pipe arm
Parapet Wall Bracket
3/8-16 SS Hex Head Bolt
(supplied)
Apply a weatherproof sealant around each fastener hole at the mounting surface.
4
Apply sealant around each fastener hole
5
Roof Mount Plate
6
Use a minimum of six (6) fasteners (not
supplied). Eight (8) fastener holes shown.
Installation Manual
AUTODOME IP starlight 5000i IR
Bosch Security Systems
Advertisement
Table of Contents
