Sony AXS-R7 Service Manual page 54

3. Remove the IF-1318 board.
(1) Remove the tape AS (0932).
(2) Remove the two screws, and then remove the plate (IF).
(3) Remove the IF-1318 board assembly from the two bushes (IF).
(4) Remove the two bushes (IF) from the two bosses.
Plate (IF)
CN100
IF-1318 board
assembly
Bushes (IF)
Bosses
Note
When attaching the tape AS (0932), observe the following instructions.
• Arrange the harness flatly so that harness leads do not overlap with each other.
• Attach the tape so that the tape edge comes to the location edge as shown above.
• Provide a margin for the harness between the IF-1318 board and the tape AS (0932).
Note
The connector CN100 on the IF-1318 board has a floating mechanism. After attaching the plate (IF), confirm that
the floating mechanism works correctly.
AXS-R7
Tape AS (0932)
PSW2 x 5
Location edge
Tape AS (0932)
IF-1318 board
2-24