Re-If-Power Harness (Disconnecting From The Connector) - Sony AXS-R7 Service Manual

2-6.

RE-IF-Power Harness (Disconnecting from the Connector)

Preparation
1. Remove the docking module. (Refer to
2. Disconnect the battery harness from the RE-340 board. (Refer to
3. Remove the rear case assembly. (Refer to
Procedure
1. Disconnect the harness.
(1) Disconnect the RE-IF-power harness from the connector (CN104) on the RE-340 board.
(2) Remove the screw.
(3) Release the harness guard PS from the boss and the slot.
RE-IF-power harness
CN104
RE-340 board
Boss
2. Install the removed parts by reversing the steps of removal.
AXS-R7
"2-2. Docking Module")
"2-3. Battery
"2-4. Rear Case Assembly")
Harness guard PS
PSW2 x 5
Hole
Harness")
Slot
2-8