Duct Assembly - Sony AXS-R7 Service Manual

2-9.

Duct Assembly

Preparation
1. Remove the docking module. (Refer to
2. Disconnect the battery harness from the RE-340 board. (Refer to
3. Remove the rear case assembly. (Refer to
4. Remove the SW-1706 board. (Refer to
5. Disconnect the RE-IF-power harness from the RE-340 board. (Refer to
from the Connector)")
Procedure
1. Disconnect the fine-wire coaxial cables.
(1) Disconnect the fine-wire coaxial cable from the connector (CN103) on the SCN-17 board (slot A).
(2) Disconnect the fine-wire coaxial cable from the connector (CN103) on the SCN-17 board (slot B).
CN103
(SCN-17 board/slot B)
CN103
(SCN-17 board/slot A)
Note
When connecting the fine-wire coaxial cable, observe the following instructions.
• Connect the two fine-wire coaxial cables to the following connectors.
Fine-wire coaxial cable from CN0600: Slot A
Fine-wire coaxial cable from CN0601: Slot B
• Before tightening four screws in step 2, arrange the two fine-wire coaxial cables under the fan section of the
duct so that they are not out of the edge of the unit at portion C.
• Push the two fine-wire coaxial cables into the space between the wall for fan and slot A/B.
AXS-R7
"2-2. Docking Module")
"2-3. Battery
"2-4. Rear Case Assembly")
"2-8. SW-1706 Board")
Fine-wire coaxial cable
(from CN0601 (DM-157 board))
Wall for fan
Fine-wire coaxial cable
(from CN0600 (DM-157 board))
Harness")
"2-6. RE-IF-Power Harness (Disconnecting
C
Fan section of the duct
CN0600
(DM-157 board)
CN0601
(DM-157 board)
Connector
Contact (gold)
Fine-wire coaxial cable
2-13