Mounting At The Control Unit - Siemens SINAMICS S120 Manual

Control Units and operating elements
4.6 Basic Operator Panel BOP20
Key
Display and operator controls of the BOP20
Additional information on the displays and operator controls of the BOP20 is available in the
SINAMICS S120 Function Manual "Drive Functions".
4.6.3

Mounting at the Control Unit

NOTICE
Damage to the BOP20 interface caused by skewed insertion or withdrawal
If the BOP20 is skewed when it is inserted or withdrawn, damage can occur to the interface on
the Control Unit.
• Make sure that you insert and withdraw the BOP20 straight into or out of the Control Unit
Table 4-37
1. Press the latching cams together and remove the
blanking cover.
92
Name Meaning
Raise The keys are dependent on the actual display and are used to raise or lower values.
Lower
and that it is not tilted up or down.
Mounting a Basic Operator Panel BOP20 using the CU320-2 DP as an example
2. Insert the memory card in the slot provided.
Control Units and additional system components
Equipment Manual, 06/2020, 6SL3097-5AH00-0BP2