Siemens SINAMICS S120 Manual page 93

Table 4-35
Display
Top left
2 positions
RUN
Top right
2 positions
S
P
C
Below, 6 digit
BOP20 keyboard
Table 4-36 Assignment of the BOP20 keyboard
Key
Control Units and additional system components
Equipment Manual, 06/2020, 6SL3097-5AH00-0BP2
Displays
Meaning
The active drive object of the BOP is displayed here.
The displays and key operations always refer to this drive object.
Is lit (bright) if the displayed drive is in the RUN state (in operation).
The following is displayed in this field:
• More than 6 digits: Characters that are present but cannot be seen
(e.g. "r2" → 2 characters to the right are invisible,
"L1" → 1 character to the left is invisible)
• Faults: Selects/displays other drives with faults
• Designation of BICO inputs (bi, ci)
• Designation of BICO outputs (bo, co)
Source object of a BICO interconnection to a drive object other than the active one.
Is (bright) if at least one parameter was changed and the value was not transferred into
the non-volatile memory.
Is lit (bright) if, for a parameter, the value only becomes effective after pressing the P
key.
Is light (bright) if at least one parameter was changed and the calculation for consis‐
tent data management has still not been initiated.
Displays, e.g. parameters, indices, faults and alarms.
Name Meaning
ON Powering-up the drives for which the command "ON/OFF1", "OFF2" or "OFF3"
should come from the BOP.
OFF Power-down the drives for which the "ON/OFF1," "OFF2," or "OFF3" commands
should come from the BOP.
Note:
The effectiveness of these keys can be defined using the appropriate BICO param‐
eterization (e.g. using these keys, it is possible to simultaneously control all of the
axes that have been configured.)
The structure of the BOP control word corresponds to the structure of the PROFI‐
BUS control word.
Functions The meaning of these keys depends on the actual display.
Note:
The effectiveness of this key to acknowledge faults can be defined using the ap‐
propriate BICO parameterization.
Parameter The meaning of these keys depends on the actual display.
Control Units and operating elements
4.6 Basic Operator Panel BOP20
91