Mitsubishi Electric MELSERVO-J2S Series Transition Handbook page 312

Part 7: Common Reference Material
MR-J2S-_CP_
No. Name
84 For manufacturer setting
85 For manufacturer setting
86 For manufacturer setting
MR-J4-_A_-RJ
Type Target No. Type
_ _ _ X
_ _ _ X
PD01 Hex
_ _ X _
_ _ X _
_ X _ _ PD41 Hex
Hex _ X _ _
_ X _ _
PD42 Hex
X _ _ _
X _ _ _
X _ _ _ PD41 Hex
X _ _ _
PD01 Hex
Hex _ _ _ X
Hex _ _ XX PD24 Hex
Hex: hexadecimal parameter; Dec: decimal parameter
7 - 73
Conversion rule
Target
The setting value will be converted to the
X _ _ _ manufacturer setting value. Do not change the
setting value.
The setting value will be converted to the
manufacturer setting value. Do not change the
_ _ _ X
setting value.
The setting value will be converted to the
_ X _ _ manufacturer setting value. Do not change the
setting value.
The setting value will be converted to the
_ X _ _ manufacturer setting value. Do not change the
setting value.
The setting value will be converted to the
_ _ _ X manufacturer setting value. Do not change the
setting value.
The setting value will be converted to the
_ X _ _ manufacturer setting value. Do not change the
setting value.
The setting value will be converted to the
_ X _ _ manufacturer setting value. Do not change the
setting value.
The setting value will be converted to the
_ X _ _ manufacturer setting value. Do not change the
setting value.
The setting value will be converted to the
_ X _ _ manufacturer setting value. Do not change the
setting value.
The setting value will be converted to the
_ _ X _ manufacturer setting value. Do not change the
setting value.
The setting value will be converted to the
_ _ X _ manufacturer setting value. Do not change the
setting value.
The setting value will be converted to the
_ _ X _ manufacturer setting value. Do not change the
setting value.
The setting value will be converted as shown in
Table 2 (as output).
However, a setting value other than those in
Table 2 will be converted to _ _0C.
When conversion of I/O signal assignment is
enabled, this parameter will be converted
_ _ XX
according to the control signal connection of the
renewal tool.
When conversion of I/O signal assignment is not
enabled, the initial value will be used.
This parameter can be used with MR
Configurator2 of software version 1.53F or later.