Table of Contents
Advertisement
Disable Character
Specifies the value of the RS-232 host command used to disable the reader.
ASCII characters or any hex value from 0 to 0xFF can be selected.
To set the value:
1. Determine the desired character or value. A setting of 0xFF indicates the
the Disable Character is not used (not available).
2. Use the
find the hex equivalent for the desired character/value.
3. Scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Program-
ming Mode.
4. Scan the bar code: SELECT DISABLE CHARACTER SETTING.
5. Scan the appropriate two alpha-numeric characters from the keypad in
Appendix D,
above. The second character will cause a two-beep indication.
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming
Mode.
This completes the procedure. See
feature.
Table 9. Disable Character Setting Examples
STEP
ACTION
1
Desired character/value
2
Hex equivalent
3
Scan ENTER/EXIT PROGRAMMING MODE
4
Scan SELECT DISABLE CHARACTER VALUE SETTING
Scan Two Characters From
5
Appendix D, Keypad
6
Scan ENTER/EXIT PROGRAMMING MODE
Programming Reference Guide
ASCII Chart on page 295
Keypad, that represent the desired character/value in step 1
EXAMPLES
'd'
0x64
'6' and '4'
USB COM (RS-232) Parameters
on the inside back cover of this manual to
Table 9
for some examples of how to set this
'}'
'D'
0x7D
0x44
'7' and 'D'
'4' and '4'
Disable Command
Not Used
0xFF
'F' AND 'F'
237
Advertisement
Table of Contents
