Table of Contents
Advertisement
Possible Cause
/usr/pil/etc/hwcon g.cf or
/usr/pcs/etc/SYSCONFIG les are set
incorrectly.
System Configuration Error
The results of START/START.F are di erent from the real con guration. For example,
is displayed for a system instrument when it is actually installed.
present
Possible Cause
The HP-IB cables are not connected
properly.
Errors during the PV4062/PV4062.F Program
Error occurs while Test Infomation of File is being Stored
As described in Chapter 6, you specify a le name in which you want to save the PV results.
For a new le, you enter test information, which will be the header information for the le.
If an error occurs while this information is being stored, the program aborts and cannot be
continued.
Possible errors and their probable causes are listed as follows: where
that you speci ed and
If an error occurs (program aborts), list the les that are on the data disk, then delete
temporary les (
TEMP001
xxxxx
Can't create
Incorrect mass storage, or a write protected device is speci ed. Or this error may occur
when reading a previously stored le, or if mass storage is full.
Can't output data to
Error when writing data to a temporary le. Disk rejected.
yyyyy
Can't copy
Error when copying a temporary le to a user speci ed le.
yyyyy
Can't purge
Error when purging temporary les.
xxxxx
Can't assign
The ASSIGN statement failed.
Error in copying data from
C-4 Installation Problems You May Encounter
is a temporary le name.
yyyyy
,
, and so on).
TEMP002
.
yyyyy
.
xxxxx
to
.
.
yyyyy
(
).
yyyyy
to
Check the settings in the /usr/pil/etc/hwcon g.cf
or /usr/pcs/etc/SYSCONFIG les. Then perform
/usr/pil/bin/pilconf command again. For details
about settings of these les, see Chapter 5.
Shut down the computer system, then turn the
system o . Con rm the HP-IB cable connections.
xxxxx
.
Solution
Solution
is the le name
xxxxx
Not
Advertisement
Table of Contents
