Connecting and setting the personal computer
Establish an IP connection for the personal computer on which ROP Setup Software is installed.
Configure the network settings of the personal computer.
Configure the network settings of the personal computer so that the same segment of the devices being connected is used.
The recommended settings are shown below.
IP address
Subnet mask
Default gateway
Setting the IP addresses of the devices
Configuring the settings using the menus
Set the IP address of the unit (ROP) in [ROP IP SETTING] under the ROP menu.
"ROP IP SETTING" (see page 124)
For the IP address of the CCU, refer to the operating instructions for the CCU.
192.168.0.200
Change the IP address if it is already used by another device.
255.255.255.0
192.168.0.1
- 132 -
Software