Panasonic AK-HRP1010G Operating Instructions Manual page 103

Item
TALLY GUARD
ASU FILTER
ASU MODE
ASU M. PED
ASU REF.FILE
ASU RECALL
CABLE CONNECT
CTRL ROTATION
TALLY CONTROL
TALLY INPUT
TALLY SIGNAL
TALLY CONT MD
When set to ON, this function disables automatic ASU, AWB, ABB operation while the tally is
ON.
Sets the operation of the ND/CC filter when auto setup is started.
REF
The filter stored in the reference file is used when operation starts.
CURRENT
Auto setup starts at the filter position made prior to startup.
Selects the auto setup mode setting.
Sets the position where the master pedestal is to be converged when auto setup is started.
Specifies the reference file used during auto setup.
Sets the reference file that is recalled when the [REF. RECALL] button is pressed.
Displays the CCU connection cable setting (display only). You can change the setting via
menu operations on the camera itself.
HYBRID
Indicates that the CCU is connected via an optical fiber multi cable.
FIBER
Indicates that the CCU is connected via an optical fiber cable.
A mode that operates based on the numerical value and a mode that operates based on the
effect are available. For details, refer to the operating instructions of the camera.
Sets whether or not to notify the camera when there is a tally input from the <PREVIEW> con-
nector. When this is set to "ON", notification is sent if there is tally input when the camera set in
[TALLY INPUT] is selected (this function is disabled when connected with a studio camera).
This is enabled when other than "Serial" and "LAN" is set in [CONNECT SETTING].
Sets the camera to be notified of tally input when [TALLY CONTROL] is set to "ON" (this func-
tion is disabled when connected with a studio camera).
This is enabled when other than "Serial" and "LAN" is set in [CONNECT SETTING].
Displays the status of tally input to the unit. "ON" is displayed when there is input, and "OFF"
when there is not.
Specifies the control method for the tally instruction when there is contact input.
SELECT
Sends notification when the camera set in TALLY INPUT is selected.
DIRECT
Ignores input and controls the camera that is connected (or to be connected).
Operation will be in the new mode at the point in time when the DIRECT/SELECT setting is
changed.
If a camera is selected while TALLY of the contact is ON when in DIRECT mode, be careful
because TALLY will remain ON for the camera before the change.
- 103 -
Setting details
ROP menu