Notice About Using Rop Setup Software; Firewall - Panasonic AK-HRP1010G Operating Instructions Manual

[SAVE] button
[LOAD] button
CAMERA List
Clicking [NETWORK SEARCH] will display the information of the cameras connected to the same network in this list.
The model name, MAC address, IP address, and port number of each camera are displayed in [CAMERA List].
The information reflected for the camera control numbers specified in CONNECT SETTING List as a result of clicking the [Reflect] button
will be only that of cameras with a camera control number set in [ASSIGN CAMERA NO].

Notice about using ROP Setup Software

When configuring settings from a personal computer using ROP Setup Software, please pay attention to the following points.
Do not start up ROP Setup Software while the unit is in the setup mode.
Do not start up ROP Setup Software on another personal computer on the same network.
After using the setup software to configure connection settings, we recommend backing up the setting data.
"ROP SETTING" (see page 118)

Firewall

If a firewall (including software) exists, allow access to UDP for all ports.
If a firewall is activated, enable the "Allow a program through Windows Firewall" setting.
1. Open the control panel, and click [System and Security].
2. Click [Allow a program through Windows Firewall] of [Windows Firewall].
3. Select the [Internet Explorer] or [HRP_Tool] line, click the [Change settings] button, and add a check to
[Internet Explorer] or [HRP_Tool].
4. Click [OK].
Stores the information set in CONNECT SETTING List on external media. Follow the instructions on
the save screen to store the information.
Loads saved data and displays it in CONNECT SETTING List. When you click the [LOAD] button, the
load screen appears. Follow the instructions on the screen to load saved data.
- 134 -
Software