Setting Up/Deleting Officer Data - Panasonic AG-RCP30P Operating Instructions Manual

Setting up/Deleting Officer Data

Before using the Memory Card Video
Recorder, you must create and configure
officer data, such as an officer ID and
officer name. For details on creating officer
data, refer to the Operating Instructions of
the Memory Card Video Recorder.
Three setup methods are available, called
the AUTO, MANUAL and LIST modes.
Check with the administrator which
mode is selected. (see page 38.)
AUTO mode
When a USB memory device is connected
to the Memory Card Video Recorder, or
when connection is detected after turning
power on, the officer data for one or
two officers is automatically read in and
activated (see the Operating Instructions
of the Memory Card Video Recorder).
Connect a USB memory device
containing officer data to a
Memory Card Video Recorder.
The [READY] lamp flashes for
one second:
This indicates that the data was
correctly read.
The [BUSY] lamp flashes for one
second:
This indicates that the data could
not be correctly read.
Disconnect the USB memory
device and then reconnect it. If
the [READY] lamp does not flash
when the USB memory device
is connected again, check if the
officer data file has been correctly
saved to the USB memory device.
If the above measures do not
correct this problem, replace the
USB memory device.
Notes:
• If a USB memory device is connected
and the officer data is read during
recording, the file will be split up
at the location where reading was
effectuated.
16
• Once the officer data has been
read, the USB memory device
may be removed.
• Once the officer data has been
set up, it is not deleted even when
power is turned off or the mode
changed.
MANUAL mode
Display the menu on the LCD panel.
Then read and load the officer data
from the Officer setup top screen.
1. Press the [MENU] button.
The Menu appears.
2. Use the [ , ] buttons to select
[Setup/Info] and press [ ] to
confirm the entry.
3. Use the [ , ] buttons to select
[Officer] and press [
confirm the entry.
The Officer setup top screen appears.
4. Connect a USB memory device
containing officer data to a
Memory Card Video Recorder.
5. Use the [ , ] buttons to select
[Officer1].
6. Use the [ , ] buttons to select
[Load] and press [ ] to confirm
the entry.
This registers officer1 and the name
and ID appear.
7. To enter officer2, replace the
current USB memory device
with a USB memory device
containing data for officer2.
8. Use the [ , ] buttons to select
[Officer2].
9. Use the [ , ] buttons to select
[Load] and press [ ] to confirm
the entry.
This registers officer2 and the name
and ID appear.
] to