Power Outlet Test - GE Dash Port 2 Service Manual

Test Equipment

Power Outlet Test

Revision A
Maintenance: Electrical Safety Tests
The recommended test equipment required to perform electrical safety
tests is listed below.
Item
Leakage Current Tester
Digital Multimeter (DMM)
Before starting the tests, the power outlet from which the monitoring
device will get electrical power must be checked. This test checks the
condition of the power outlet to ensure correct results from leakage tests.
For international power outlets, refer to the internal standards agencies
of that particular country. Use a digital multimeter to ensure the power
outlet is wired properly.
If other than normal polarity and ground is indicated, corrective action
must be taken before proceeding. The results of the following tests will be
meaningless unless a properly wired power outlet is used.
Dash Port 2 Docking Station
2000966-138
Specification
Equivalent to the circuits shown
AC volts, ohms (minimum of 10
milliohm resolution recommended)
4-7