Disassembly/Assembly Of Frus; Guidelines For Disassembly - GE Dash Port 2 Service Manual

Disassembly/Assembly of FRUs

Guidelines for Disassembly

Tools Required
Before Disassembly
Hardware Assemblies
6-16
Part Lists, Drawings, and Replacement: Disassembly/Assembly of FRUs
:$51,1*
REPAIR TO THE FRU LEVEL — Field repairs are
recommended to the field replaceable unit (FRU) only.
Attempting a field repair on a PCB or a factory sealed
component or assembly could jeopardize the safe and
effective operation of the docking station.
127(
GE recommends that you assemble the docking station using the
NEW fasteners (screws, washers, etc.) provided in the Field
Replaceable Unit kit. Some fasteners, like the screws with a thread
locking coating, are NOT intended to be re-used more than three
times.
A standard set of hand tools is required for disassembly and assembly.
Before you disassemble the docking station, you should ALWAYS remove
AC power.
When disassembling the docking station, observe the following
guidelines:
Provide appropriate electrostatic discharge protection and handle all
PCB assemblies by their edges to prevent damaging the PCB.
Note the positions of wires, cables, and different sized screws;
marking them if necessary to ensure they are replaced correctly.
Save and set aside all hardware for re-assembly.
Dash Port 2 Docking Station
2000966-138
Revision A