Table of Contents
Advertisement
De-Installation
1. Disconnect power supply and ground.
Depending on how the device was installed:
Option 1: By using t-taps: Disconnect the plugs from the t-taps and leave the t-taps on the cable of the dome light, TCU power
supply cable, OBD cable.
Option 2: By using an adapater (OBD adapter or fuse box adapter): Remove the adapter completely.
Option 3: By using ring connectors: Remove the ring-connectors completely.
2. Detach the split 2 from the split 1 cable.
2. Pull the split 2 cable over the a-pillar.
4. Remove the device from the windshield.
Use a putty metal knife to carefully slide between the device glue pad and the windshield.
Gently move the putty metal knife from side to side to detach the glue pad from the windshield.
Pull down the putty metal knife to remove the device from the windshield.
5. Clean the windshield with an isopropyl alcohol wipe or with a soap and water mixture.
IMPORTANT:
The t-taps used will remain in the vehicle and shall not be removed.
IMPORTANT:
Take care during the usage of the putty metal knife to not scratch the windshield.
IMPORTANT:
Removal of the device may be easier when the interior of the vehicle is a higher temperature (at least 10°C).
24
Cross-Domain Computing Solutions | 2022-01-27
© Robert Bosch GmbH 2021. All rights reserved, also regarding any disposal, exploitation, reproduction, editing, distribution, as well as in the event of applications for industrial property rights.
Advertisement
Table of Contents
