4) Adhere the device onto the vehicle windshield
Carefully remove the adhesive tape paper liner without disturbing its adhesion to the
unit
First, place the top edge of the unit (edge facing headliner with cable attached). Slowly
roll the rest of the unit onto the windshield
Due care should be taken to prevent air bubbles between the windshield and the
adhesive backing
The power cable and unit label must be facing upward toward the roof of the vehicle,
or else functionality will be affected
The unit should be pressed onto the windshield by hand with moderate pressure for at
least 30 seconds for required adhesion. Once installed, the unit should ideally remain
untouched for 30 minutes to allow the adhesive tape to fully cure to the windshield.
However, holding strength will be achieved very quickly
IMPORTANT:
As stated in the safety guidelines, do not pound on the device for any
reason as this could crack the vehicle's windshield.
22
Cross-Domain Computing Solutions | 2022-01-27
© Robert Bosch GmbH 2021. All rights reserved, also regarding any disposal, exploitation, reproduction, editing, distribution, as well as in the event of applications for industrial property rights.