Table of Contents
Advertisement
3.3) Connect to fuse box
After the preparations are done:
Route split 2 of the wire harness from the specified device location to
the fuse box. This is usually done by routing up the A-pillar and over
the headliner
Attach split 1 and split 2
Identify a suitable ground location and connect the ring connector
accordingly
Identify the correct location to get power from the fuse box (see previous
page) and plug in the fuse box adapter
IMPORTANT:
Please make sure, that the cable in the engine compartment
is secured by insulation tape.
IMPORTANT:
Please make sure, that the cable routed over the a-pillar
does not interfere with the side airbag system.
20
Cross-Domain Computing Solutions | 2022-01-27
© Robert Bosch GmbH 2021. All rights reserved, also regarding any disposal, exploitation, reproduction, editing, distribution, as well as in the event of applications for industrial property rights.
Connect ground to ground
with ring connector
Advertisement
Table of Contents
