3.1) Connect to dome light
Open the dome light with a prying tool
Locate the power plug and ensure constant 12V power
Attach 1 x t-tap to the ground wire and 1 x t-tap to the power
wire using pliers
Connect the device to the t-taps
Optional: Use insulation tape or zip ties to secure the remaining
device cable in the dome light compartment
Reattach the dome light
IMPORTANT:
The correct connector must match the t-taps placed
on the vehicle wire harness: wire labeled (GND) goes to the vehicle
ground wire (brown in this example), and wire labeled (+12V) goes
to vehicle power (red in this example).
IMPORTANT:
Please make sure that the device cable is not folded
or squeezed by the dome light compartment.
Required tools (may be different depending on your vehicle):
Pliers
Prying tool
15
Cross-Domain Computing Solutions | 2022-01-27
© Robert Bosch GmbH 2021. All rights reserved, also regarding any disposal, exploitation, reproduction, editing, distribution, as well as in the event of applications for industrial property rights.
1
3
5
2
4
6
7