Symbols Used - Bosch rexroth PE 2/X Assembly Instructions Manual

16/40 Assembly
Table 6: Symbols used
1 2
SW13
M = 20Nm
D
SW5
M = 8Nm
D
T15
M 8Nm
PZ2
PH3
ISO-FLEX Klüber
TOPAS Struktovis
NCA 52 GHD
GHD V 68
Loctite 243 Loctite 601
1 2 3
A B C X
Bosch Rexroth AG, MIT: PE 2/X, PE 2/H, PE 4, 3 842 564 350/2020-06

7.4 Symbols used

Connection with T-bolt and fl ange nut.
Make sure the T-bolt is in the correct position when inserting into the
slot and tightening. The notch at the head of the bolt indicates the orientation
of the T-bolt.
1 = T-bolt insertion position in the slot
2 = T-bolt clamping position in the slot
Tightening torque: 25 Nm
Hex wrench
SW = width across fl ats in mm
M = required tightening torque in Nm
D
Allen keys
SW = size in mm
M = required tightening torque in Nm
D
Torx keys
T = Torx no.
M = required tightening torque in Nm
D
Screwdrivers for cross-head screws
PZ ... = Pozidriv screw drive size ...
PH ... = Phillips screw drive size ...
Lubricate/lubricate with specifi c grease lubricant:
• ISO-FLEX TOPAS NCA 52: www.klueber.com
• Klüber Struktovis GHD: www.klueber.com
Lubricate/lubricate with specifi c mineral oil:
• GHD: Structovis GHD, www.klueber.com
• V 68: mineral oil with a viscosity of 68
Secure the screws with:
• Loctite 243: medium strength (detachable), www.loctite.de
• Loctite 601: high-strength screw retention (non-detachable), www.loctite.de
The marked parts are not required for the described assembly.
Dispose of the parts or use them for other purposes.
Graphical depiction of the installation steps.
The numbers correspond to the sequence of mounting steps, in accordance with
the instructions in the accompanying text.
Designation of components in graphics.
The letters denote the components mentioned in the accompanying text.
Detail view from a different direction, for example of the back or the bottom side
of the product.