Chapter 2 Hardware
2.7 Tool Connection Connector (TOOL)
2
This connector is an USB port for PC connection. It is used to check the automatic setting status of
I/O and collect RAS information by the terminal software of PC. It is used for setting and
maintenance of the FL654A module by nV-Tool. For how to use it, see Chapter 5, I/O configuration
information, Chapter 7, RAS Function, Chapter 8, Startup Using nV-Tool and Chapter 9,
Maintenance Using nV-Tool.
The connector and connection cable are as follows:
・
Connector:USB connector (B type)
・
Connection Cable:USB cable (AB type)
10
6F8C1625
TOOL
Figure 2-7 Tool Connection Connector (TOOL)