Toshiba TH850A Instruction Manual page 43

Hexagon socket head
cap screw (M4x6)
Fig. 5.4 Cover concurrently used for connector panel
When mounting the cover, apply the liquid gasket to the area shown in Fig. 5.4
above. Especially, apply much more liquid gasket to the cover folded sections.
After the assembly, coat the liquid gasket throughout the cover set surface to fill a
gap between the gasket, cover and base. Also, apply the Loctite adhesives to all
set bolts.
• Be sure to attach the gasket and apply the liquid gasket. Also, be sure to
coat the Loctite adhesives to all set bolts. Otherwise, the dust- and
drip-proof performance is damaged to cause entry of water or dust.
2) The latter cover is secured to the base with four (4) cross-recessed truss head
screws (M4 × 6) by inserting the gasket. The gasket set surface is coated with
the liquid gasket. Remove the cover while carefully peeling off the liquid gasket,
using a slotted screwdriver, etc. As the cover is connected with the connectors
inside, DO NOT pull out the cover by force.
DUST- & DRIP-PROOF TYPE SPECIFICATIONS MANUAL
Gasket
Cover also serving as
connector panel cover
Cross-recessed
truss head
screw (M4x6)
!
CAUTION
– 43 –
Folded sections
Apply the liquid gasket
throughout this surface.
STE 80765