Miele KWT 6833 SG Operating And Installation Instructions page 45

Display warnings
Message
The alarm symbol  is
lit up in the display. The
three sensors for the
wine conditioning zones
are flashing in the
control panel. An
audible alarm is also
sounding.
The alarm symbol  is
flashing in the display,
and the sensor for one
of the wine conditioning
zones is also flashing.
An alarm tone is also
sounding.
The Change Active
AirClean filter symbol
 is lit up.
A dash is lit up up/
flashing in the display.
"F0" to "F3" or
"S1" to "S3" appear in
the display.
Cause and remedy
The door alarm has been activated.
 Close the door. The three sensors for the wine
conditioning zones and the alarm symbol  will
go out and the audible alarm stops.
The temperature in the zone concerned has risen
higher or fallen lower than the temperature set.
Possible reasons for this include:
– The appliance door has been opened too
frequently.
– The ventilation gaps have been blocked.
– A prolonged power cut (power outage) has
occurred.
 Rectify the cause of the alarm. The alarm
symbol  goes out and the sensor for the
affected wine conditioning zone lights up again
constantly. The alarm will stop.
This is the reminder to change the Active AirClean
filters.
 Replace the Active AirClean filters in all three wine
conditioning zones and then confirm the filter
change in settings mode (see "Active AirClean
Filters").
Only temperatures within the range the wine
conditioning unit can display will be shown.
There is a fault.
 Call Service.
Problem solving guide
45