D-Link Nuclias Connect Hub Plus DNH-200 User Manual page 65

Nuclias Connect Hub Plus User Manual
Configuration > Profile Settings > [Site] > [Network] > Bandwidth Optimization to view
existing settings.
Enable Bandwidth
Optimization
Downlink Bandwidth
Uplink Bandwidth
Rule Type
Band
SSID Index
Downlink Speed
Enable or disable bandwidth optimization. Enable this to
configure with the following settings.
Enter the total downlink bandwidth for the access points
in Mbits/sec.
Enter the total uplink bandwidth for the access points in
Mbits/sec.
Select the rule type:
Allocate average

Optimize bandwidth by averaging the allocated
bandwidth for each client.
Allocate an upper limit of bandwidth for each

station: Specify the maximum bandwidth for each
connected client, while reserving available
bandwidth for other uses.
Allocate different bandwidth limits for 11a/b/g/n

station: The weights of 802.11b/g/n and 802.11a/n
clients are 10%/20%/70% and 20%/80%
respectively. The AP will distribute different amount
of bandwidth for 802.11a/b/g/n clients.
Allocate specific bandwidth for SSID: All clients

share the assigned bandwidth.
Select the wireless frequency band used in the rule.
Select the SSID used in the rule.
Enter the downlink speed assigned to each station or the
65
bandwidth for each station:
AP Network