Table 3-5 Required Alarm System Equipment - Motorola iDEN Site Controller System Manual

Chapter 3 Pre-Installation
Alarm Wiring
3-24
Table 3-5 lists the equipment required for pre-installation of alarm system
wiring.
Table 3-5 Required alarm system equipment
Part number
3083892X04
3083892X07
1
0183652P01
2
3084966K06
2
2882174W03
1
Punch Block 2 is used strictly for customer defined inputs and outputs for systems with 3 or
fewer RF racks. If 4 or more RF racks are used, see Chapter 4-50 for redefinitions of Punch Block
2 pins for use with additional RF racks.
2
Used only for systems with 4 or more RF racks. See Figure 4-17 for cabling information and
diagram.
Connect site alarm wiring using the following procedures. Refer to
Figure 3-4 and Figure 3-5. Table 3-6 and Table 3-7 list the punch block
pinouts.
Connect the necessary wires (alarms) to the punch blocks.
1.
Connect the 50 pin Champ (alarm) cables to the punch blocks.
2.
Gen 3 Site Controller System Manual
Description
50 pin Champ cable, 25' (for alarms) for EAS
50 pin Champ cable, 25' (for alarms) for EAS2
punch block
50 pin Champ cable, 3' (to modular plug adapter)
6 modular plug adapter
68P80801E30-A 5/1/2002