Figure 4-19 Eas/Eas2 To Punch Block 1 And Punch Block 2 Connections - Motorola iDEN Site Controller System Manual

Gen 3 Site Controller System Manual
PUNCH BLOCK 2

Figure 4-19 EAS/EAS2 to punch block 1 and punch block 2 connections

Alarm System Cabling
68P80801E30-A 5/1/2002
-48V RTN
MOTOROLA
ENVIRONMENTAL USER ALARM/CONTROL
ALARM SYSTEM
-48V , 0.5A
INPUT:
EAS2
USER ALARM/CONTROL
RTN
-48V
CONTROLLER A
PARALLEL SERIAL
EAS
3083892X04 (EAS)
3083892X07 (EAS2)
Locate the 50-pin Champ cable connected to punch block 1.
1.
Connect the free end of this cable to the System Alarm/Control
2.
connector on the rear of the EAS/EAS2.
Locate the 50-pin Champ cable connected to punch block 2.
3.
Connect the free end of this cable to the User Alarm/Control
4.
connector on the rear of the EAS/EAS2.
The Environmental Alarm System (EAS/EAS2) handles alarms for the site.
Site alarm wiring enters from the top of the equipment cabinet via the
junction panel. Connector pinouts for the junction panel are the same as
EAS/EAS2 connector pinouts.
CONTROLLER A CONTROLLER B
CONTROL RF1
PARALLEL PARALLEL
RF2 RF3
CONTROLLER B
PARALLEL SERIAL CONTROL RF#1 RF#2 RF#3
3083892X04 (EAS)
3083892X07 (EAS2)
PUNCH BLOCK 1
Chapter 4 Installation
Intercabling Connections
SYSTEM ALARM/CONTROL
SYSTEM ALARM/CONTROL
Motorola -48V , 1.0A
ENVIRONMENTAL ALARM SYSTEM
iSC407
042202JNM
4-41