Boot Menu - Panasonic EBL512 Operating Instructions Manual

Panasonic Electric Works Fire & Security Technology Europe AB
MEW00748 Rev: 1
21.1
Operating Instructions Fire alarm system EBL512 V2.3.x

Boot menu

The Boot menu should be used by authorised personnel only!
NOTE! Vital data can be erased via this menu.
The Boot menu is opened as follows:
Perform a reset / restart:
• Power off / power on
or
• Jumper JP4 on the main board
The following text messages will be show in the alphanumeric
display:
Checking program memory......
And after that:
Booting......
When the text "Booting......" appears, press "Access" and 0.1 sec.
later also press "1" and the Boot menu will be shown:
1:Reset, 2:Clear mem, 4:Read AD, 5:MSClo
ck, 6:Checksum, 7:Cursor, 8:Texts
Press "1" to perform a reset / restart (i.e. you will also leave the Boot
menu).
Press "2" to open the Clear memory menu, see below.
The other alternatives are for R & D use only!!
The Clear memory menu:
1 = SSD, 2 = SSW, 3 = SysInfo, 4 = Echel
oninfo, 5 = Texts
Press "1" to clear the SSD memory.
Press "2" to clear the SSW memory.
The other alternatives are for R & D use only!!
"Erasing SSD" and "Erasing SSW" respectively will be shown and
then will the Clear memory menu be shown again.
Press "Return" go back to the Boot menu.
NOTE! After clearing the SSW, perform a "Power off / power on"
reset / restart directly.
70
Can also be done in Win512, EBL512 settings dialog box, "Clear SSD".
71
70