Re-Enable Control Output (H2/B6) - Panasonic EBL512 Operating Instructions Manual

Panasonic Electric Works Fire & Security Technology Europe AB
MEW00748
24.6
Action
"Access"
Scroll to menu H2.
"A"
Scroll to menu B6.
"A"
"A"
Depending on the
chosen type, 0, 1, 2, 3
resp. 4, the following
will be shown:
Rev: 1

Re-enable control output (H2/B6)

Disabled outputs are listed in menu H4/U1 from which it is also
possible to get a print-out.
When all control outputs have been re-enabled, The LED
"Disablements" (L8) will be turned OFF, if there are no other
disablements in the system.
Text in display
Disable or re-enable
Disable zone
Re-enable control output
Re-enable control output type: 0
0=Loopunit 1=S 2=R 3=RE 4=ES
(4=ES not valid in Swedish (SBF) convention)
Re-enable 00 0000 output 0
Re-enable control unit 00 S0
Re-enable control unit 00 R0
Re-enable control unit 00 relay board 0
output 0
Re-enable output for extinguishing
system on 1583 board, CU 00
Operating Instructions Fire alarm system EBL512 V2.3.x
ACCEPT? H2
ACCEPT? B1
ACCEPT? B6
ACCEPT?
ACCEPT?
ACCEPT?
ACCEPT?
ACCEPT?
ACCEPT?
82
Comments
According to chapter
"Access", see page 72.
Press:
"0"=RU4 (2265) or
SU4 (2262 / 2263) or
MIO (3361) or
ASI (3377) or
ASB (3378)
"1"=S0-S3
"2"=R0-R1
"3"=Relay board 1581
"4"=1583 board output
"Extinguishing system".
Press "A" to accept.
If there are no outputs to
L
re-enable, menu B6 will be
shown again.
L=a list in which you can
L
scroll.
Regarding the ASI (3377)
L
& ASB (3378) units:
Output:
L
0=high priority
1=medium priority
L
2=low priority
If it's the correct output to
re-enable, press "A" to
accept. If not, scroll or
write the wanted output
and press "A" to accept.