Canon imagePRESS Server G200 Configuration And Setup page 79

Job mismatch settings
This section provides some examples of the expected behavior of various combinations of the job mismatch settings.
The mismatch settings are available in Configure, under Job Management > Job Mismatch. For more information
about the mismatch function, see Command WorkStation Help.
Settings in Setup and Configure
Please note the slight differences between the mismatch-related settings that are available in the Setup feature on the
printer control panel and the settings that are available in Configure.
Setup on printer control panel
Enable Suspend On Mismatch
Mismatch Timeout
Cancel Processing Upon Mismatch
Workflow example 1
Assumptions:
•
Enable Job Mismatch is On.
•
Mismatch Action is set to Cancel.
•
Timeout is set to 5 minutes.
If a mismatch job occurs, the following happens:
1 An error message about the mismatch appears in Command WorkStation, but does not appear on the printer
control panel.
Note: The message does not appear on the printer because the job was never sent to the printer.
2 You have the timeout period (default is 5 minutes) to correct the mismatch, for example, by loading the correct
size of paper.
3 If no action is taken, after the timeout period (default is 5 minutes) the message disappears and the job is
canceled.
Note: If you look at the Job Log in Command WorkStation, the job appears as canceled.
Workflow example 2
Assumptions:
•
Enable Job Mismatch is On.
•
Mismatch Action is set to Suspend.
•
Timeout is set to 5 minutes.
If a mismatch job occurs, the following happens:
In Configure
Enable Job Mismatch
Timeout
Cancel job processing after time out expires
Configuration and Setup
Configuring print job management settings
79