Display; Numbers; Operating States; Information - Bosch Rexroth ID 40 Manual

10/176 About this manual
Bosch Rexroth AG, MIT: ID 40, 3 842 530 344/2014-05
PROOF COPy 1 | 20.05.2014 | FOR INTERNAL USE ONLy
• Chapter 10 describes the web interface for MDT data diagnostics and start-up
support.
• Chapter 11 explains the steps for starting up the ID 40 on fieldbus systems.
• Chapter 12 shows control procedures using some typical applications. The
corresponding ID 40 code sequences for the Profibus system are also listed.
• Chapter 13 can be used as a reference for running system diagnostics. It also
contains a troubleshooting guide.
• Chapter 14 contains all technical data.
• Chapter 15 contains an overview for ordering available system components.
• The appendix (Chapter 16) contains a glossary of all technical terms and the link
model for the ID 40 system.

1.3 Display

1.3.1

Numbers

• Decimal numbers are written without a suffix,
e.g., 123
• Hexadecimal numbers are written with the prefix "0x",
e.g., 0x0002001C
• Data blocks are written with their address and length in bytes as
<address>/<length>,
e.g., 0x00000815/25
1.3.2

Operating states

• The operating states of the read/write head are written in uppercase and in italics,
e.g., CONNECTED
1.3.3

Information

Symbol Meaning
Information marked with the "Caution" symbol must be strictly observed
for your safety.
Important information is marked with the "Info" symbol. It is intended to
provide support and should be observed.
Individual, independent action
f
1. Numbered instruction:
The numbers indicate that the actions must be carried out one after the
2.
other.
3.