Samsung DCS Programming Manual page 14

SAMSUNG DCS
TECHNICAL MANUAL
MMC: 105
DESCRIPTION:
Allows the system administrator or technician to program the personal speed dial locations
assigned to a station. This must be done for single line telephones because these stations cannot
access programming. Each station may have up to 50 locations or bins assigned to it in MMC
606 Assign Speed Block. The speed dial bins are numbered 00–49. Each speed dial number
consists of a trunk or trunk group access code followed by a separator and up to 18 digits to be
dialed. These dialed digits may consist of 0–9, [ and #. If the system recognizes a valid trunk or
trunk group access number, it will automatically insert the separator.
PROGRAM KEYS
UP & DOWN
KEYPAD
SOFT KEYS
SPK
HOLD
B
C
D
E
F
ACTION
1. Press TRSF 105
Display shows
2a. Dial station number (e.g. 205)
OR
Press UP or DOWN to select station
and press RIGHT soft key to move cursor
OR
Press LEFT soft key to go to step 4
2b. If selected station has no speed dial
bins, the display will be as shown and
a new station may be selected
3. Dial location number (e.g., 05)
OR
Press UP or DOWN to select location
and press RIGHT soft key to move cursor
OR
Press LEFT soft key to return to step 2
4. Enter trunk access code (e.g., 9)
followed by the number to be dialed
Used to scroll through options
Used to enter selections
Move cursor left and right
Used to store data and advance to next MMC
Used to clear previous entry
Used to insert a flash code "F"
Used to insert a pause code "P"
Used to insert a pulse/tone conversion code "C"
Used to mask/unmask following digits (shows as "[" or "]")
Used to enter name for speed dial bin (see MMC 106)
STATION SPEED DIAL
DISPLAY
[201] SPEED DIAL
00 :
[205] SPEED DIAL
00 :
[205] SPEED DIAL
SPDBLK NOT EXIST
[205] SPEED DIAL
05: _
[205] SPEED DIAL
05 : 9-4264100_
PROGRAMMING
December 1996