Selecting A Gamma Curve; Ip Address - Sony UP-DF550 Manual

To reset another type of blue thermal
film to the default status
Repeat steps 1 to 4.

Selecting a Gamma Curve

When the gamma curve is not specified at the modality
side, the unit makes printouts with the gamma curve
selected on the printer side. You can select the gamma
curve to be used for each type of blue thermal film.
1,8
4,6
2,5
3
1
Press the MENU button.
2
Display the GAMMA SEL menu by pressing the F
or f button, then press the g button.
The unit enters the gamma selecting mode.
3
Press the g button.
The gamma curve setting menu for UPT-517BL
film sheets appears.
When the desired gamma curve is displayed,
display the type of blue thermal film the gamma
curve of which you want to change by pressing the
f button.
Here the instructions for changing the gamma curve
for UPT-517BL film sheets are given.
4
Display the desired gamma curve by pressing the G
or g button.
The gamma curve for SONY 1 has been pre-set,
you cannot change these settings.
The gamma curves for USER 2 to USER 20 can be
set to the desired value. For advice on the settings,
contact your nearest Sony dealer.
Display the desired gamma curve by pressing
the G or g button.
Gamma curve Setting
SONY 1 Default setting (standard and basic
curve)
USER 2 to USER Each gamma curve has been preset to
5 the proper settings based on the
SONY 1 gamma curve.
USER 6 to USER Not preset. For advice on settings,
20 contact your nearest Sony dealer. If
you select one of these gamma curves,
USER 6 to USER 20, before setting,
the same setting as that of SONY 1 is
applied.
5
Select the next desired blue thermal film the gamma
curve of which you want to change by pressing the
F or f button.
6
Display the desired gamma curve by pressing the G
or g button.
7
Repeat steps 5 and 6 to change the gamma curve for
the remaining blue thermal films.
8
Press the MENU button.
The unit returns to standby status and the size and
remaining amounts of each film type are displayed
on the LCD.

IP Address

You can set the IP address, sub-net mask and default
gateway address using the SYSTEM SETTINGS menu
to connect the printer to the LAN network.
33
Menu Operation