Sony UP-DF550 Manual page 22

unit counts the remaining film sheets using the IC
tag on the printing protection sheet on the bottom
of the pile of sheets.
6
Remove the seal used to secure the film sheets in
the package from the film sheets placed in the film
tray.
1 Remove the sticky part of the seal, pulling the
blank part of the seal toward you.
2 Pull the blank portion of the seal out of the film
tray, and remove the seal from the film tray
completely.
Note
If the seal is caught by the cover of the film tray,
or is left curled in the film tray, this may cause
film sheet jamming. Be sure to remove the seal
completely from the film tray.
22
Loading Film Sheets
3 Close the film tray cover.
7
Insert film tray 1.
After a few seconds, the film tray is locked and the
following message appears on the LCD.
Notes
• Be sure to insert film tray 1 all the way into the
unit until it stops. When the film tray is not
inserted completely and the film sheets are not
loaded correctly, the following message appears
on the LCD.
• If you try to insert the film tray into the wrong
film tray side, you cannot do so because the