Sony UP-DF550 Manual page 14

L Front cover lock lever
Used to open the front cover.
M Film output slot
Printed film sheets (printouts) are ejected from film
tray 1 here.
N Film tray 1 (19)
Reserved for use with UPT-517BL film sheets.
Load UPT-517BL film sheets into this tray. Also,
ejected film sheets accumulate on this tray.
O Film tray 2 (19)
Load the desired film sheets from among the UPT-
514BL/512BL/510BL film sheets into this tray.
Since the size of each type of film sheet is different,
you must adjust the size for the film sheets you are
using. The size of the film tray has been adjusted for
UPT-510BL film sheets at the factory. For details
on using the UPT-512BL or UPT-514BL film
sheets, consult your Sony dealer.
P 1ON/STANDBY switch/indicator (18)
Press this switch to set the unit power to on. When
the power is on, the indicator lights in green. To set
the unit power off, press this switch again. The
indicator blinks, and then goes off.
Pressing this switch while the indicator is blinking
turns the power back on.
Note
If the ?/amain power switch on the rear panel is
not set to on, the power is not on even though the
1ON/STANDBY switch on the front panel is
pressed.
Q EXEC button (28)
Use this button in menu operations.
R G, g, F, f (Cursor control) buttons (28)
Press these buttons to increase or decrease the
setting values. Also press these buttons to select
menu items.
S MENU button (28)
Press this button to display menus on the printer
window display. Also press this button to return to
the normal window.
T Rear cover 1 (43)
Open this cover when removing jammed film
sheets loaded in film tray 1.
U Rear cover 2 (43)
Open this cover when removing jammed film
sheets loaded in film tray 2.
14
Location and Function of Parts and Controls
V
Network connector (RJ-45 modular jack)
(17)
Conforms to the 100BASE-TX standard. Used to
connect to a LAN.
Caution
For safety, do not connect the connector to
peripheral device wiring that might have excessive
voltage.
Follow the instructions for use for this port.
W Cable stopper
Secures the network cable to prevent it from being
disconnected.
X -AC IN connector (17)
Use the proper power cord for your local power
supply (not supplied). Refer to "Warning on power
connections" on page 8.
WARNING
To disconnect the main power, unplug the power
plug.
When installing the unit, incorporate a readily
accessible disconnect device in the fixed wiring, or
connect the power plug to an easily accessible
socket-outlet near the unit.
Do not position the ME equipment where it is
difficult to unplug the power plug.
If a fault should occur during operation of the unit,
operate the disconnect device to switch the power
supply off, or disconnect the power plug.
Y ?/amain power switch (18, 18)
This switch is the main power switch of the unit.
Turns the unit on or off. When this switch is set to
on, the unit power is on when the 1ON/STANDBY
switch on the front panel is pressed.
Z
Equipotential ground terminal connector
Used to connect to a ground (equipotential) plug to
bring the various parts of the system to the same
potential.
Refer to "Important safeguards and notices for use
in the medical environments" on page 3.