Connections; Turning The Unit On Or Off - Sony UP-DF550 Manual

Secure the unit using the front caster
(sold separately).
Stopper sheet
(sold separately)
Secure the front caster using the stopper sheet
(sold separately).
Be sure to place the roller of the caster in the groove
of the stopper sheet.
Notes
• Be sure to use casters and stopper sheet (sold
separately) when placing the unit vertically.
Otherwise, the unit may topple and cause injury.
• When pulling the unit in and out while the unit is
equipped with the casters, be careful not to damage the
power cord, LAN cable, and so on.
• When placing the unit vertically, make sure the LCD
is near the floor, and leave a space of more than 8 cm
(3 1/4 inches) between the top of the unit and the
anything located above it to prevent blocking the
ventilation holes.
Stopper sheet
(sold
separately)

Connections

Connect the unit to a 100BASE-TX LAN.
Notes
• Connect the AC power cord last.
• Before connecting to the LAN, be sure to set up the
required IP address and sub-net mask.
For detailed information, consult the system
administrator.
to the network connector
100BASE-TX
cable
to the LAN
Notes on the 100BASE-TX cable
• Be sure to use a network cable of less than 30 m (98
feet 5 1/4 inches) in length, and rated more than
category 5.
• It is recommended that you use a shielded cable.

Turning the Unit On or Off

Turn the printer power on after you connect the AC
power cord.
to- AC IN
Power cord
17
Connections