Flexible NC programming
1.1 Variables
● For access to protected elements from cycles, the execution and write rights for cycle
● The write rights of the local HMI cycle directories must be set to the same protection level
Subprogram calls in ACCESS files
To structure access protection further, subprograms (SPF or MPF identifier) can be called in
ACCESS files. The subprograms inherit the execution rights of the calling ACCESS file.
Note
Only access rights can be redefined in the ACCESS files. All other attributes have to
continue to be programmed/redefined in the corresponding definition files.
46
directories _N_CST_DIR, _N_CMA_DIR, and _N_CST_DIR have to be modified.
Execution rights
– MD11160 $MN_ACCESS_EXEC_CST
– MD11161 $MN_ACCESS_EXEC_CMA
– MD11162 $MN_ACCESS_EXEC_CUS
Write rights
– MD11165 $MN_ACCESS_WRITE_CST
– MD11166 $MN_ACCESS_WRITE_CMA
– MD11167 MN_ACCESS_WRITE_CUS
The execution right has to be set to at least the same protection level as the highest
protection level of the element used.
The write right must be set to at least the same protection level as the execution right.
as the local NC cycle directories.
References
/BAD/ Operating Manual, HMI Advanced,
Chapter: Services operating area > Data administration > Modify properties
Programming Manual, 06/2009, 6FC5398-2BP20-0BA0
Job Planning