Operation Of Operator Panel Fronts; Simulation Of Part Programs - Siemens SINUMERIK 840D sl Function Manual

3.3.3

Operation of operator panel fronts

The system responds as follows, for example, when two operator panel fronts are operated
in the configuration illustrated below:
1. For the NCU, there is no difference whether the input is from the MMC or OP030 operator
2. The operator panels are mutually independent in terms of data display, i.e. the display
3. Spontaneous events, such as alarms, are displayed on both control units.
4. The protection level with the highest authorization in accordance with the lowest activated
5. The system does not provide for any further co-ordination between the operator panels.
For further information, please refer to
References:
/FB2/ Function Manual, Extended Functions; Several Operator Panel Fronts and NCUs (B3)
3.4

Simulation of part programs

Windows 32s, version 1.30.166.0 or higher, must be installed in order to operate part
program simulation.
For notes on operation, see
References:
/BA/ Operator's Guide
Extended Functions
Function Manual, 01/2008, 6FC5397-1BP10-3BA0
panel front.
selected on one panel is not affected by the display on the other.
protection level number applies to both operator panel fronts.
Operation via PG/PC (B4)
3.4 Simulation of part programs
273