Nck-Spl Program - Siemens SINUMERIK 840D Description Of Functions

11.03
3.10 Safe programable logic (SPL) (840D SW 4.4.18)
•
•
Fig. 3-33
3.10.1

NCK-SPL program

Description The NCK-SPL program is written as an NC program (synchronous sub-routine)
with synchronized actions.
References: /FBSY/
Features The NCK-SPL program has the following features:
•
•
© Siemens AG 2003 All Rights Reserved
SINUMERIK 840D/SIMODRIVE 611 digital SINUMERIK Safety Integrated (FBSI) - Edition 11.03
Crosswise data comparison checks whether the "commissioning phase"
has been completed. If errors are detected in the crosswise data
comparison, a "STOP D/E" is triggered on the NCK/611 digital depending
on this criterion. If the commissioning phase has not been completed,
Alarm 27095 "SPL protection not activated" is displayed once after run-up
and the commissioning status between NCK and PLC cross checked.
As far as the SPL-SGAs are concerned, if an error occurs for a crosswise
data comparison, then a system response is not issued. In this case, the
user must program his own response in the SPL.
NCK
I/Os
HW
in-
puts/
ouputs
NCK monitoring channel
Result and data
Machine
cross-check
Drive monitoring channel
HW
inputs/
out-
puts
PLC
I/Os
Process
Communications between the NCK-611 digital PLC components
Description of Functions, Synchronized Actions
The program can be started manually with NC START during
commissioning.
The following applies once the program has been started:
− The synchronous actions assigned an ID No. are cyclically executed in
the IPO clock cycles (modal)
− The synchronous actions assigned the keyword IDS remain active even
after an operating mode change or NC-STOP/NC RESET
3 Safety-Related Functions
NCK signal
Interface
processing
NCK
NCK
signal
SGE/SGA
pro-
signals
cessing
Result and data
cross-check
PLC
NC/PLC
signal
interface:
pro-
Axis/
cessing
spindle DB
PLC signal
Interface
processing
System
Comparator
Data
Comparator
Data
SPL033.DSF
3-139