Initial Commissioning; Unpack The Wbe; Setting Up The Wbe; Fitting The Wheel-Guard Hood - Bosch Start Line WBE 260 Original Instructions Manual

4.

Initial commissioning

4.1

Unpack the WBE 260

1. Remove the steel band and fasteners.
2. Carefully lift off the packaging.
3. Remove the accessories and packaging material
from the packaging unit.
i
Check that the WBE 260 and the accessories are in
proper working order and that there are no visi-
ble signs of component damage. In case of doubt,
do not commission the unit and consult customer
service.
i
Dispose of the packaging material at an appropriate
collection site.
4.2

Setting up the WBE 260

1. Unfasten locating screw on WBE 260.
2. Attach hoisting strap as shown in illustration. The
hoisting strap must be at least the same length, and
must have enough load-bearing capacity (at least
100 kg).
Fig. 3: Lifting the wheel balancer
Initial commissioning | Start Line WBE 260 | 27
Warning of damage or wrong lifting gear
Risk of injury if WBE 260 falls.
¶
Please check hoisting strap before
attaching it.
¶
Secure the hoisting strap.
¶
Lift the WBE 260 carefully.
3. WBE 260 must never be lifted by the flange shaft.
After lifting, set down at prepared installation lo-
cation and pay attention to the minimum specified
distance.
Fig. 4: Wheel balancer installation location
i
For safety reasons, the installation location must be
500 mm away from the wall.
4. WBE 260 must be secured to the ground with ex-
pansion bolts. Measuring errors will occur if it is not
fixed firmly.
4.3

Fitting the wheel-guard hood

1. Remove nut from support bracket on the 2 wheel-
guard hoods, then remove the support bracket.
Fig. 5: Unfastening the guard hood
en
|
1 695 600 539 2016-07-22