User Information; Important Notes; Safety Instructions; Electromagnetic Compatibility (Emc) - Bosch Start Line WBE 260 Original Instructions Manual

2.

User information

2.1

Important notes

Important information on copyright, liability and warran-
ty provisions, as well as on equipment users and com-
pany obligations, can be found in the separate manual
"Important notes on and safety instructions for Bosch
Tire Service Equipment". These instructions must be
carefully studied prior to start-up, connection and opera-
tion of the WBE 260 and must always be heeded.
2.2

Safety instructions

All the pertinent safety instructions can be found in
the separate manual "Important notes on and safety
instructions for Bosch Tire Service Equipment". These
instructions must be carefully studied prior to start-up,
connection and operation of the WBE 260 and must
always be heeded.
2.3

Electromagnetic compatibility (EMC)

The WBE 260 satisfies the requirements of the EMC
directive 2004/108/EG.
i
The WBE 260 is a class/category A product as
defined by EN 61 326. The WBE 260 may cause
high-frequency household interference (radio inter-
ference) so that interference suppression may be
necessary. In such cases the user may be required to
take the appropriate action.
User information | Start Line WBE 260 | 25
3.

Product description

3.1

Intended use

The WBE 260 is a wheel balancing machine featuring
mechanical wheel clamping for the balancing of car,
light van and motorcycle wheels with a rim diameter of
10" - 27" and a rim width of 1" -
The WBE 260 is to be used exclusively for this purpose
and solely for the range of applications specified in
these instructions. Any other purpose is not consistent
with the intended use and is therefore not permissible.
i
The manufacturer cannot accept any liability for pos-
sible damage arising from improper use.
!
* These dimensions refer to standard rims (A); for
1)
rims with a special shape (B - C), special accesso-
ries should be used.
A
B
C
Fig. 1: Rim types
3.2

Prerequisites

The WBE 260 must be installed on a flat surface
made of concrete or similar material and anchored in
position.
!
An uneven or vibrating surface can lead to inaccu-
rate unbalance measurements.
!
Any uneven floors or that do not meet the previously
expressed safety requisites relieve the manufactur-
er from any liability for damages to persons and/or
property.
en
20".
|
1 695 600 539 2016-07-22