Huawei E9000 Troubleshooting Manual page 30

Huawei Servers
Troubleshooting
Data
Table 4-5
Table 4-5 Data list
Parameter
IP Address
Subnet mask
Default gateway
The default username of the switching plane is root, and the default password is
Huawei12#$.
Software Tools
wftpd32.exe: used to transfer files between different platforms, for example, from
a PC to a switch module. This tool is third-party software. You need to prepare it
by yourself.
Procedure
Step 1 Configure the FTP server.
For detailed about the configuration operations, see
Server.
Step 2 Configure the IP address of the management network port.
1.
Issue 20 (2020-09-25)
describes the required parameters.
NO TE
You can query and set IP addresses of all modules. For details, see
MM910 WebUI.
● For the MM910 versions earlier than (U54) 2.20, choose System Management >
Network Management >
● For the MM910 (U54) 2.20 or later, choose Chassis Settings > Network Settings >
After logging in to the switch module by using a serial port or the SOL
function, run the following commands on the switching plane CLI to query
and set the IP address of the management network port so that the switch
module can properly communicate with the FTP server:
NO TE
Skip this step if you log in to the switch module by using a network port.
<Fabric>system-view
[Fabric]interface MEth 0/0/1
[Fabric-MEth0/0/1]ip address
[Fabric-MEth0/0/1]display this
#
interface MEth0/0/1
Copyright © Huawei Technologies Co., Ltd.
Example Value
CX911: 192.168.1.100
CX912: 10.77.77.77
255.255.255.0
0.0.0.0
xx > IP addresses.
192.168.100.123 24
4 Collecting Information
8.11 Logging In to the
8.20 Configuring an FTP
xx .
21